how do i replace worktops without breaking the tiles

grahamadgo · Post by **grahamadgo** » Sun Sep 21, 2008 11:42 pm

hi i want to replace my worktops whilst keeping the existing tiling. I have a u shaped kitchen.

i am ok with fitting the new one, ive done that before but could do with some tips on how to remove the old one whilst minimising the risk of breaking the existing tiles

any tips would be appreciated

thanks
g

Post by **ultimatehandyman** » Mon Sep 22, 2008 8:17 am

The worktop will be fastened from underneath, so remove all screws.

Where the worktop is jointed ther should be some clamping bolts, which clamp the worktops together, these are normally rebated into the worktop, these will also need removing.

Once you have done that you should be able to slide the worktop out from under the tiles, but if the tiler did not leave a gap then it may be difficult to remove and so be careful. You may have to lift the front edge of the worktop upwards to release it, so take your time and keep an eye on the tiles.

Hoovie · Post by **Hoovie** » Mon Sep 22, 2008 8:24 am

be worthwhile running a sharp blade along under the bottom edge of the tiles where they butt onto the worktop to free any connection between the two - in case the silicon joint between tile and worktop is stronger then bond between tile and wall

marc1106 · Post by **marc1106** » Mon Sep 22, 2008 4:09 pm

take off the plinths andadjust the rear legs of the cabinet so they are just "off the floor" this will also make it easier to slide new tops in.
When done just adjust legs back down again! easy peasy

Tryanything · Post by **Tryanything** » Mon Sep 22, 2008 5:34 pm

marc1106 wrote:take off the plinths andadjust the rear legs of the cabinet so they are just "off the floor" this will also make it easier to slide new tops in.
When done just adjust legs back down again! easy peasy

I'm with that

Griffin · Post by **Griffin** » Sun Oct 26, 2008 3:34 pm

Assuming of course that you have adjustable feet on your units and not floor to worktop cheeks!