deep skirting

Deano72 · Post by **Deano72** » Sun Nov 16, 2008 3:37 pm

can anyone recommend a manual saw that can cope with 168mm deep skirting boards?

Thanks

Geewizz · Post by **Geewizz** » Sun Nov 16, 2008 3:55 pm

Am I missing something here?

I wouldn't use a junior hacksaw but just about any handsaw could cut a skirting board that is 168mm wide.
Start the cuts with a mitre saw and then use a handsaw. Plane or sand them to a finish.

Hoovie · Post by **Hoovie** » Sun Nov 16, 2008 4:30 pm

Only problem I have found myself with deep skirting is doing the Mitres as mitre boxes always seem way too small.

Apart from that .....

Deano72 · Post by **Deano72** » Sun Nov 16, 2008 4:57 pm

sorry guys

i meant a mitre saw - with the blocks
the ones i've seen are too small!

Geewizz · Post by **Geewizz** » Sun Nov 16, 2008 5:09 pm

Back to basics then. Use your mitre to cut two blocks of wood to 45 degrees. Position one block either side of the coving you want to cut and clamp them against your measured mark. Start sawing with the saw up against the cut faces of your blocks.

Or you could always hire a cut-off saw from your local tool hire shop.

Deano72 · Post by **Deano72** » Sun Nov 16, 2008 5:14 pm

much appreciated

how come the simple things are always the best