Hi Everyone,
Have fitted a new pullcord switch for shower at home.
Everything is fine except when I pull switch to off, light on switch stays on!
I think it's a wiring problem - have I got my black neutral wires wrong way round?
All advice very welcome
Thanking eveyone in advance
regards,
Mark.
PULLCORD SWITCH - LIGHT STAYS ON WHEN OFF
Moderator: Moderators
-
uncle buck
- Senior Member
- Posts: 268
- Joined: Wed Feb 28, 2007 12:17 pm
- Location: Newcastle T&W
- Has thanked: 0
- Been thanked: 1 time
Best to remove the pull cord switch & start again….
The terminals inside the switch should be marked…. “Supply” & “Load”
The wires from the shower go into the Load terminals.
The wires that feed the power to the switch go into the Supply terminals.
Always switch off at the fuse box before you start any electrical work.
The terminals inside the switch should be marked…. “Supply” & “Load”
The wires from the shower go into the Load terminals.
The wires that feed the power to the switch go into the Supply terminals.
Always switch off at the fuse box before you start any electrical work.