Worktop edging strip

juandan · Post by **juandan** » Sun Jun 24, 2007 8:54 am

Hi, can you tell me the best adhesive for putting the edging strip on the end of the worktop, I've been using PVA adhesive and sealer I have to use a weight on the strip and leave it for a few hours to make it stick I was told to use it by B&Q I now have a 2m length so I can't put a weight on the end of that

panlid · Post by **panlid** » Sun Jun 24, 2007 8:57 am

i just use impact adhesive.

juandan · Post by **juandan** » Sun Jun 24, 2007 10:30 am

can give me a name?

panlid · Post by **panlid** » Sun Jun 24, 2007 11:30 am

http://www.screwfix.com/app/sfd/cat/pro ... 2&id=38770

juandan · Post by **juandan** » Mon Jun 25, 2007 8:57 am

Thanks for the reply Panlid, but its a bit expensive £2.99 for the adhesive and £5.95 for packing and handling I can get it local for £4.99 but thanks for telling me the name of the adhesive

skiking · Post by **skiking** » Mon Jun 25, 2007 9:53 am

Try B&Q - they sell it as well altho' a little pricier (improved version

) plus they do a tube for less than a couple of quid.

panlid · Post by **panlid** » Mon Jun 25, 2007 11:08 am

dont get solvent free. imo it is crap.

peteyweakstraw · Post by **peteyweakstraw** » Fri Jun 29, 2007 5:18 am

If you're looking for an adhesive, you should probably use Scotch-Weld Urethane Adhesive. It has two parts in it that makes it resistant to the cold and heat. This is a wonderful product that has long lasting durability.