Good afternoon all,
I have just laid WR chipboard down in the bathroom, i know i know should have used 25mm marine ply but to late now so i am going to lay 6mm ply down befor i fit UFH and tile.
Question is, is 6mm ply ok or should it be min 8mm?
What size ply?
Moderator: Moderators
-
Every Little Helps
- Newly registered Member
- Posts: 8
- Joined: Wed Dec 07, 2011 11:43 am
- Has thanked: 1 time
- Been thanked: 0
-
Every Little Helps
- Newly registered Member
- Posts: 8
- Joined: Wed Dec 07, 2011 11:43 am
- Has thanked: 1 time
- Been thanked: 0
Re: What size ply?
Answers below:
- 300x300, Travertine tiles
- Room is 4mx2.5m
- Joists are 300mm apart.
Much appreciated for your helps
- 300x300, Travertine tiles
- Room is 4mx2.5m
- Joists are 300mm apart.
Much appreciated for your helps
-
tictic
- Senior Member
- Posts: 518
- Joined: Fri Sep 25, 2009 6:09 pm
- Has thanked: 5 times
- Been thanked: 23 times
Re: What size ply?
ufh and travertine tiles.....
your going to need an uncoupling membrane ...ditra....
mate rip up that chipboard and replace with 18mm wbp then a 10mm insulation board...will be cheaper in the long run....
with stone tiles/ufh and "chipboard" its a failure waiting to happen imo.
your going to need an uncoupling membrane ...ditra....
mate rip up that chipboard and replace with 18mm wbp then a 10mm insulation board...will be cheaper in the long run....
with stone tiles/ufh and "chipboard" its a failure waiting to happen imo.