Last Base unit runs out 10mm on end of run

manny · Post by **manny** » Sat Mar 14, 2015 7:38 pm

Hello.. What's the best method to resolve the above issue.

The bottom of wall comes out a bit so the bottom of the unit, 1000mm base unit right side only, touches the wall but leaves a gap at the top.

I can't pull the unit off the wall to align it as this will mean the wortop overhang will be almost non existent.

Do I scribe the base unit back to the wall or do I chop out the plaster(bow in wall) that's causing the unit to run out of line.

fin · Post by **fin** » Sat Mar 14, 2015 7:46 pm

scribe it to the wall.

Bill Darr · Post by **Bill Darr** » Sat Mar 14, 2015 8:09 pm

Take the plaster off at the point the bottom of the unit is touching.

Job and Knock · Post by **Job and Knock** » Sat Mar 14, 2015 8:19 pm

Either. I'd probably scribe the unit as it's less messy - unless it was an IKEA one with no service void

philprime · Post by **philprime** » Sat Mar 14, 2015 8:24 pm

I'd scribe to the wall

Last Base unit runs out 10mm on end of run

Last Base unit runs out 10mm on end of run

Re: Last Base unit runs out 10mm on end of run

Re: Last Base unit runs out 10mm on end of run

Re: Last Base unit runs out 10mm on end of run

Re: Last Base unit runs out 10mm on end of run