Could I bend 9mm plasterboard to a sharp curve of around 4" 90 degrees?
I've got a solid former to bend against and fix in the form of a curved corner post. The pieces of board will be approx 12" high. This is for a bulkhead below a ceiling.
I thought I could try a combo of cutting back of board and damping to get the curve?
What is the solution for beading the bottom edge?
Sharp radius plasterboard
Moderator: Moderators
-
davyp1
- Senior Member
- Posts: 700
- Joined: Thu Mar 09, 2017 4:47 pm
- Location: East Riding of Yorkshire
- Has thanked: 13 times
- Been thanked: 181 times
Re: Sharp radius plasterboard
oz0707 wrote:
What is the solution for beading the bottom edge?
I'm assuming the 'bottom edge' you refer to is a reflex angle!
In that case (or with an angle other than 90, you would use a
'thin skim stop bead'.
https://www.google.co.uk/search?hl=en&s ... mdfMdlaMKE
davyp1