Recently acquired a very old Myford ML8 woodturning lathe with loads of turning tools ect , looked a bit tatty but it all works fine, well once the wiring was replaced and the old MEM starter unit relay contacts bent straight and carefully cleaned.
Not had a lot of time yet so really only a couple of trials so far:
Bit of wood turning
Moderator: Moderators
-
Chippo1
- Senior Member
- Posts: 1073
- Joined: Mon Sep 14, 2015 7:36 pm
- Location: Cambridgeshire
- Has thanked: 10 times
- Been thanked: 194 times
Bit of wood turning
- Attachments
-
- 163760FF-7193-4899-9F75-81E76C0EDF71.jpeg (175.66 KiB) Viewed 5458 times
-
- 62F96152-A64C-440B-8DEB-6E115877C30F.jpeg (199.9 KiB) Viewed 5458 times
-
London mike 61
- Senior Member
- Posts: 1586
- Joined: Fri Aug 01, 2014 8:57 am
- Location: Essex
- Has thanked: 285 times
- Been thanked: 402 times
-
moderator7
- UHM Super Moderator
- Posts: 454
- Joined: Thu Oct 20, 2016 5:41 pm
- Has thanked: 27 times
- Been thanked: 63 times
-
Jonstephens
- BANNED
- Posts: 2
- Joined: Fri Jan 24, 2020 9:52 am
- Has thanked: 5 times
- Been thanked: 0