Hello,
I’m looking to rewire a couple of old table lamps and a floor lamp. All brass / metal.
The floor and newer table lamp have brass bayonet lamp holders with what I think is an earth terminal on the outside and two terminals inside.
Am I correct in thinking that the earth goes into the outside terminal and live and neutral can go in either terminal inside? (not marked live/neutral)
The other table lamp is antique brass & metal and has no lamp holder / cable. Can I fit a similar brass lamp holder as above here and connect as above? Or are there any other steps or considerations?
Appreciate any advice.
Thanks
Re-wiring Floor & Table Lamps
Moderator: Moderators
-
Someone-Else
- Senior Member
- Posts: 14709
- Joined: Sat Sep 01, 2012 6:03 pm
- Has thanked: 47 times
- Been thanked: 2590 times
Re-wiring Floor & Table Lamps
- blh.jpg (44.27 KiB) Viewed 1129 times
And FYI it matters not which way round the live and neutral go, as you can take the lamp out, turn it 180 degrees and put it back, so in effect swapping live and neutral.
Above are my opinions Below is my signature.
Would you hit a nail with a shoe because you don't have a hammer? of course not, then why work on anything electrical without a means of testing Click Here to buy a "tester" just because it works, does NOT mean it is safe.
If gloom had a voice, it would be me.
Click Here for a video how to add/change pictures
Inept people use the QUOTE BUTTON instead of the QUICK REPLY section
Would you hit a nail with a shoe because you don't have a hammer? of course not, then why work on anything electrical without a means of testing Click Here to buy a "tester" just because it works, does NOT mean it is safe.
If gloom had a voice, it would be me. Click Here for a video how to add/change picturesInept people use the QUOTE BUTTON instead of the QUICK REPLY section