Is this a Danfoss TS715

stevei · Post by **stevei** » Thu Nov 03, 2022 6:27 am

: Danfoss ts715.jpg (133.88 KiB) Viewed 986 times

The buttons on this CH controller are are bit iffy. Is this a Danfoss TS715 and is there a direct replacement for it, one that could use the original back plate?

aeromech3 · Post by **aeromech3** » Thu Nov 03, 2022 9:53 am

It looks very similar to the Danfoss Randall TS715SI which I understand does fit same back plate. But later model TS710 (also single Channel) & FP720 (dual channel) does not fit this back plate, I would assume more modern units will Not.
Wait for more informed replies.

stevei · Post by **stevei** » Thu Nov 03, 2022 9:09 pm

I've found the cover from this. It is a Danfoss TS715 but about 20 years old.

stevei · Post by **stevei** » Sat Nov 05, 2022 4:00 pm

I called Danfoss tech and told them which time switch I needed to replace. They said the Danfoss TS710 product code 087N7884. They also make a TS710 with product code 087N7881. I'm assuming the 7881 is the one that cannot be used with the same back plate. They are readily available but I'm struggling to find a 7884.

Someone-Else · Post by **Someone-Else** » Sat Nov 05, 2022 5:36 pm

Could you not call Danfoss and ask them who sells it?

stevei · Post by **stevei** » Sat Nov 05, 2022 9:45 pm

Someone-Else wrote: ↑Sat Nov 05, 2022 5:36 pm Could you not call Danfoss and ask them who sells it?

Yes, but not until Monday morning.

stevei · Post by **stevei** » Thu Feb 02, 2023 12:55 pm

Update on this post. I managed to get 4 Danfoss TS710 product code 087N7884 and these were fitted to the existing back plates. No wiring alterations needed and they are working well.