Nail gun for working with pallet wood

[Jontygee]

Hi

I am looking for some advice on purchasing a nail gun.

My main projects will be using pallet wood and I intend to use them for a multitude of projects, e.g. building planters. building shelves, candle holders, bird boxes, seasonal figures e.g halloween and xmas, and lots of jobs both big and small.

Up to now I have used screws, but am thinking I could really do with a nail gun, but am really confused by the different types needed for pallet wood.

Having looked at a lot of advice, i feel I am looking at a 2nd fix nail gun, as I feel a brad nail gun will be too lightweight for pallet wood??

So I was thinking of a 16 gauge rather than an 18 gauge, and like the look of the Dewalt DCN660N, but it is very expensive so want to know it will be suitable for my purposes?

Any advice gratefully received

Thanks

John

[dewaltdisney]

I have not used one but I am asking are 16 or 18 gauge pins substantial enough for holding the pallet wood together. I have found pallet wood fairly poor quality and splits around ends are common when nailing and pull throughs. I do not know if I would spend the money on a cordless one, I have a cheap pneumatic pinner that works well off my small compressor. If you are workshop based then air or corded tools will work and they will be a lot cheaper. Just a view.

DWD

[Someone-Else]

When I read the post title, I immediately thought of an air powered nail gun, then reading your post, I see dewaltdisney has said the same thing. I just looked at the cost I would still get an air powered one for the reasons dewaltdisney says, AND you can get a tyre inflator for a compressor too.

[Jontygee]

thanks very much for your two replies, both much appreciated.

I guess I just needed a view on whether a nail gun would work with pallet wood of varying size and thickness. Most of the articles I have read refer to use with floorboards, skirting etc, but can't find anything that really concentrates on pallet projects.

I am not really wedded to cordless or corded or compressor driven, it's just whether I would be wasting my time buying a nail gun to use on the hard pallet wood.

For the smaller projects that needed more precision I would use glue with a nail gun, but for the outdoor planters, raised beds etc, which can be more rustic, i would probably stick to screws

thanks

John

[dewaltdisney]

John, have a look at this https://www.screwfix.com/p/titan-ttb517 ... 240v/71120 This should be fine for lots of your small work. For the bigger stuff, I would say stick to screws

DWD

[big-all]

i have both the ryobi 18 and 16 gauge nail guns you reallly need a collated gun with "D"shaped heads as the 16 is only a panel pin size