12V to mains

JohnBishop · Post by **JohnBishop** » Thu May 02, 2024 11:03 am

big-all wrote: ↑Thu May 02, 2024 9:13 am if you look at the saw is the writing on the blade mostly hidden??

Do you mean if the engraving on the old blade is worn off?

big-all · Post by **big-all** » Thu May 02, 2024 12:45 pm

Does the arrow on the blade rotate the same way when you run the saw(possible blade on back to front??)

JohnBishop · Post by **JohnBishop** » Thu May 02, 2024 1:45 pm

big-all wrote: ↑Thu May 02, 2024 12:45 pm Does the arrow on the blade rotate the same way when you run the saw(possible blade on back to front??)

so the arrow on the blade correspond with the arrow on the plastic guard.
It cuts from below rather than from the top. Is that right?

big-all · Post by **big-all** » Thu May 02, 2024 2:12 pm

the teeth must point forward in direction off rotation

JohnBishop · Post by **JohnBishop** » Fri May 03, 2024 2:43 pm

I check ed with the video and it rotates like in the video so luckily the blade wasn't the other way round.