Page 2 of 2
Re: Avoiding 3 finger salutes?
Posted: Thu Mar 19, 2015 6:27 pm
by big-all
as you know jxk with work in place there should be no gap greater than 6mm [1/4] so that device is to protect the stupid
although to be fair when the guards are remover for cleaning purposes------------------
Re: Avoiding 3 finger salutes?
Posted: Fri Mar 20, 2015 12:01 am
by Job and Knock
big-all wrote:to be fair when the guards are remover for cleaning purposes------------------
On that basis, Americans must have the cleanest saws in the world......... Despite all the missing fingers/hot dogs
Re: Avoiding 3 finger salutes?
Posted: Fri Mar 20, 2015 12:43 am
by big-all
to me its all about attitude respect and knowledge
respect the tools
know the dangers from all angles
and dont use any tool if and when you have a negative "attitude"
