Page 1 of 1
Square edge laminate worktop fitting?
Posted: Wed Oct 14, 2020 7:50 pm
by Blakey
Hi all,
Could someone advise me, what is the procedure for 90 degree joins on square edge laminate?
All/any advice greatly appreciated.
Square edge laminate worktop fitting?
Posted: Wed Oct 14, 2020 8:08 pm
by darrenba
Traditionally I've always done a mason mitre with router and jig. However this week I used this method and it's worked well.
https://www.youtube.com/watch?v=Q46oq6WV2kI
Square edge laminate worktop fitting?
Posted: Thu Oct 15, 2020 12:17 pm
by Bob225
That poor, poor 2" Marple chisel
Square edge laminate worktop fitting?
Posted: Fri Oct 16, 2020 8:35 pm
by darrenba
Here's the result
- IMG_9211.jpeg (528.51 KiB) Viewed 2625 times
- IMG_9210.jpeg (569.26 KiB) Viewed 2625 times
Square edge laminate worktop fitting?
Posted: Sat Oct 17, 2020 10:20 pm
by fin
ive always used the router and jig method. seen it butt joined also... never actually done a one though