www.ultimatehandyman.co.uk

i recently tiled limestone tiles on a wall and when it dried i cud c wre the tile had contacted the wall. it shows either trowel marks or blobs wre iv had 2 build ot. i tried sealing the tiles bt the marks are stile there. does any1 have any suggestions on ow 2 fix this r prevent this happening.
I also have 2 lay limestone tiles on the floor and am unsure of how 2 stop it happening again. the wall tiles are 11mm thick and the floor tiles are 20mm thick

There is not much you can do about it now.

The incorrect adhesive and wrong trowel seem to have been used-

Fitting marble tiles

I would try and answer this if I could understand bloody texted talk

Only-Me wrote:I would try and answer this if I could understand bloody texted talk

ur nt tryng hrd enuf m8

its nt dfclt u knw

Wot