Page 1 of 1
Bedding shower tray down
Posted: Sun Jul 12, 2009 9:24 pm
by sandyman
Hi Again
Yet another question if ya dont mind...
How much cement/rapid fix should I use to bed the new shower tray onto ???
The tray is a 900x900 quadrant.
Cheers
Sandy
Posted: Tue Jul 14, 2009 12:01 pm
by sandyman
what can nobody give me any idea about fixing this shower tray down
Cheers
Sandy
Posted: Tue Jul 14, 2009 12:08 pm
by thescruff
The question would be better asked in the plumbing forum.
What tray is it, and what does the manufacturers instructions say about bedding the tray.
Normally a weak ish mix sand and cement 5-1 is fine.
Posted: Tue Jul 14, 2009 2:17 pm
by Razor
The simple answer is a lot more than you would think! Between one and two buckets to get a proper base but you do need to use the right stuff as directed by the manufacturer.
Posted: Tue Jul 14, 2009 6:35 pm
by bathstyle
I would estimate that you will need approx 10kg of cement based rapidset flexible adhesive
Posted: Tue Jul 14, 2009 9:12 pm
by sandyman
Ok thanks chaps, will give it a go and see what happens. The manufacturers destructions dont say how much should be used.
I will go with the 10kg and see.
Thanks for all your input chaps
Sandy