www.ultimatehandyman.co.uk

good moaning!

I need to mount some pumps and flow sensors in the new bathroom build. I will make an enclosure in the same boxed wall for the concealed toilet cistern for them.

however they need to be accessible.

what is the best way to make an accessible panel that will be tiled? I want it to look like it is not there

Have seen KeKu clips? any good?

or I do recall seing some sort of flush magnet system?

what do you guys reccomend?

thanks
Dave

manthorpe flush magnet systems look good like these: http://www.manthorpe.co.uk/Building/Pro ... Panel.html

Colour Republic did a bathroom and discussed briefly access another-little-bathroom-t34668.html from Schluter (forgive spelling) near bottom of the page.

Hope that you can access the link ok.

Why not put them in the cupboard with the cylinder as discussed.

Thanks guys, ive just bought these

http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... 0560261473

bonded to the back of some tiled marmox board should do the trick!

Hi Scruff, absolutley NO room in the new cylinder location i'm afraid.

So where is it going. No room is not usually a good option.

davemulheran wrote:good moaning!

I need to mount some pumps and flow sensors in the new bathroom build. I will make an enclosure in the same boxed wall for the concealed toilet cistern for them.

Going there. The ST universal pump is a bit of a beast!