Page 1 of 1
grease/heat stained pine
Posted: Mon Jan 07, 2008 12:12 pm
by Rich-Ando
the other day we had an Indian takeaway. the missus put everything on the table mats except my Kima Nan. the packet was hot and had grease on the side. by the time i had noticed what she had done (only about 1 minute) it had produced a 4"/2" white smear type of mark.
although i am more than verse with sanding the whole table down to a perfect flat smooth finish i am not verse with methods of polish or repairs.
is there any way for me to remove this mark without sanding?
it is a solid Ducal pine table.
Posted: Mon Jan 07, 2008 5:34 pm
by peter c
Mrs C did something very similar with a candle on an oak bessemer fireplace. I got most of it out using an iron (medium heat) with white blotting paper in between. Basically the iron melts the fat and it is absorbed by the blotting paper.
I'm not sure if it will take the finish of the table off though.
Peter C
Posted: Mon Jan 07, 2008 5:51 pm
by Rich-Ando
hmm, not one i would have thought of Peter, thanks for your input, i'll bear it in mind.
Posted: Mon Jan 07, 2008 6:48 pm
by Hitch
So its the finish thats damaged?
We had some damage on a worktop, totaly different... but a bit of vegetable oil rubbed well into it and its now invisible.
Might be worth a quick go as a temporary solution.
Posted: Mon Jan 07, 2008 9:06 pm
by Tryanything
Im sure there used to be a product called ring remover which was used for removing white ring marks left by hot cups
Posted: Mon Jan 07, 2008 9:50 pm
by Steve. F
Yes
Ring remover
Now i got a tube of that somewhere. i used it once to remove some heat marks left on an indian jali table with a waxed finish.
I got the stuff from my grandmother years ago whod probably herself had it for years so couldnt even say if its still available today,Which would be a great shame if not because this stuff is a miracle in a tube, totally removed the white marks which nothing else would even look at, restoring my table to its former glory.
Posted: Mon Jan 07, 2008 10:15 pm
by big-all
definatly not oil hitch
its oil and several other ingrediants that are staining the surface
all depends if the stain is on the surface or a bit deeper !!!
if its deeper i would go for the blotting method
wood is a bit like a sponge but not as good as blotting paper or kitchen roll
if you warm the area through absorbant paper some off the oil will transfer but any "colour "in the residue may remain
try the blotting paper trick twice and if you still have a stain try warm soapy water to try and release the stain then quickly warm and blott again
now you will have the chance of driving stain even deeper with warm water but hopfully it will be dilluted strength and remove a lot with blotting up
Posted: Mon Jan 07, 2008 10:20 pm
by Hitch
Ah, is it an unfinished table then?
Whats ducal btw, a style of furniture isnt it?
Posted: Mon Jan 07, 2008 10:23 pm
by big-all
Hitch wrote:Ah, is it an unfinished table then?
Whats ducal btw, a style of furniture isnt it?
not shure realy alterd my origional post to cover both options
Posted: Mon Jan 07, 2008 11:58 pm
by Rich-Ando
thanks very much everybody. Ducal is just a branded make of pine. around here it is supposed to be a decent manufacturer but when i look at it i just think "hmm, so what, i could make it just as good"
i must admit i did cringe a bit when i read the "RING REMOVER" suggestion, i just couldn't picture the table
it looks like it might be surface and not deep so here goes, ill give it a shot.