25mm screed
Posted: Sat Jan 04, 2014 6:40 pm
Hi,
I intend to screed a floor by 25mm, ready for tiling, using a 4:1 mix of sharp sand and cement.
Is this advisable or is this too thin a coating, which will then be susceptible to cracking etc?
I have been advised to maybe using chicken wire underneath or add 'BOND SBR'. Would anyone here recommend either of these 2 steps?
Could I use standard mortar plasticiser rather than the SBR stuff?
Thanks guys
replies here please. Mod 2.
screed-fibres-sbr-and-cement-slurry-hel ... 70991.html
I intend to screed a floor by 25mm, ready for tiling, using a 4:1 mix of sharp sand and cement.
Is this advisable or is this too thin a coating, which will then be susceptible to cracking etc?
I have been advised to maybe using chicken wire underneath or add 'BOND SBR'. Would anyone here recommend either of these 2 steps?
Could I use standard mortar plasticiser rather than the SBR stuff?
Thanks guys
replies here please. Mod 2.
screed-fibres-sbr-and-cement-slurry-hel ... 70991.html