Page 1 of 1
Ply floor
Posted: Tue Oct 02, 2018 8:37 am
by ronson
Hi mayve a silly question but I'm no pro but i am a confident diy tiler , all the floors I've done at my home have had a concrete sub base that I've screeded and then tiled with no problem, what I've got is a small down stairs toilet but the floor is chipboard, now I know I need to ply it but a tiler mate has said I need to lay it in one piece ? My question is how do I get a single piece if ply in the room ? It's an odd shape with the waste in one corner ? I just can't see how I could do it ?
Sent from my SM-G955F using Tapatalk
Re: Ply floor
Posted: Tue Oct 02, 2018 9:21 am
by ayjay
ronson wrote: now I know I need to ply it but a tiler mate has said I need to lay it in one piece ?
.........and what would he recommend if the floor was larger than a single sheet of ply?
Re: Ply floor
Posted: Tue Oct 02, 2018 9:24 am
by ronson
That's what I mean , the rooms only 1.7 x 1.5 so it can be done in a single piece but no way it will go in like that , if I cut it in half I can no problem
Sent from my SM-G955F using Tapatalk
Re: Ply floor
Posted: Tue Oct 02, 2018 9:32 am
by Ktuludays
Cut it in half to allow you to fit it. I always use a good strong tape over any joins. I use the t-rex tape.
Sent from my HUAWEI VNS-L31 using Tapatalk