Page 1 of 1

External corners on bevelled subway tiles

Posted: Thu Oct 04, 2018 8:09 pm
by Jonno34
Putting new tiles on my kitchen wall splashback. Just chewing over how to do 2 external corners. Was thinking of edging strip but as these are in a brickwork pattern some will butt up with the bevel and some with the middle which is thicker. Will this look OK?

Suggestions welcome!

TIA

Re: External corners on bevelled subway tiles

Posted: Thu Oct 04, 2018 9:15 pm
by dewaltdisney
I used metal trim on my metro tiling. I used pre-made metal corners to take the three trims convergence at the corner neat. The trim settles to where you can push it and you can lay the adhesive on a bit thicker to get it all level and looking good. I bought trim and bits from here https://www.protilertools.co.uk/categor ... im-corners

DWD