Artex swirl pattern

Whilst there are many textured ceiling and wall finishes available, most people associate these with Artex!These finishes are put on as a liquid and then patterned, they are like thick paint when applied, Textured finishes come in ready mixed, cold mix and warm water mixes.Many patterns are available and the difficult ones are best left to the professionals but there are plenty of patterns which the keen DIY enthusiast can attempt successfully.

Swirls is a pattern that is relatively easy to achieve. This is a sample of a swirl pattern you can make it a lot deeper by applying the Artex thicker.

Artex can be very messy so overalls and safety glasses are a must!

• To apply Artex to a ceiling or wall it is important to have the room as cool as possible with no draughts, so turn off the radiator and close the windows. The windows can be opened once the Artexing has been finished!
• Bond the whole area with PVA bonding. This will stop the Artex from drying out too fast and give you more time to pattern it.
• When Artexing you do not do too large an area at once or you will never get the pattern before it has started to harden.

Use a large brush and load it generously with the Artex.

Cover an area of approximately 1metre by half a metre with an applicator brush, ensuring that it is applied generously.

Here you can see that an area has been covered with artex, we are now going to pattern this area.

Using a stippling brush touch it onto the surface and spin it around.

This creates the swirl pattern and can be very effective.

Remove the stippling brush cleanly after creating each swirl.

Overlap each swirl to give the desired swirl pattern

• Make sure there are no obvious squares where you have joined each area together and try to blend them all in together. Overlapping areas can easily be blended whilst it is still wet.
• Work speedily but safely as Artex can go off very fast and make working it very difficult.