tile cutter blades

lovley jublee · Post by **lovley jublee** » Tue Jun 19, 2007 4:22 pm

hi all, i have overcome a pva problem by soaking it out and sanding it downt hen going over it with pda (thanks for the advice),now its tile cutting.i have bought a screwfix 600 watt diamond blade cutter but it takes ages cutting a tile, iam using 12mm travertine tile so is this why or are there different grades of diamond blade so much so that the difference of cutting the tile will take 30 seconds instead of 5 or 6 mins, should i be looking at buying a different blade ? thanks in advance, and thankyou for your help with the pda poblem rob

Post by **ultimatehandyman** » Tue Jun 19, 2007 4:30 pm

I think a different machine would be better.

Natural stone of that thickness will not cut easily on such a small machine. Pro tilers use much larger machines for cutting such tiles.

The one from screwfix will cut them but very slowly, if you have lots of cuts then you may be better off hiring a larger machine.

lovley jublee · Post by **lovley jublee** » Wed Jun 20, 2007 7:16 am

i thought that you may say that, oh well ill carry on and do the basic bits then leave all main cuts and do in one hit when i hire one .Thanks again as that has saved me wasting a lot of time. keep up the good work