Putting new tiles on my kitchen wall splashback. Just chewing over how to do 2 external corners. Was thinking of edging strip but as these are in a brickwork pattern some will butt up with the bevel and some with the middle which is thicker. Will this look OK?
Suggestions welcome!
TIA
External corners on bevelled subway tiles
Moderator: Moderators
-
dewaltdisney
- Senior Member
- Posts: 17058
- Joined: Fri Jan 20, 2006 5:51 pm
- Location: Essex
- Has thanked: 820 times
- Been thanked: 3519 times
Re: External corners on bevelled subway tiles
I used metal trim on my metro tiling. I used pre-made metal corners to take the three trims convergence at the corner neat. The trim settles to where you can push it and you can lay the adhesive on a bit thicker to get it all level and looking good. I bought trim and bits from here https://www.protilertools.co.uk/categor ... im-corners
DWD
DWD