Square edge laminate worktop fitting?

Blakey · Post by **Blakey** » Wed Oct 14, 2020 7:50 pm

Hi all,
Could someone advise me, what is the procedure for 90 degree joins on square edge laminate?

All/any advice greatly appreciated.

darrenba · Post by **darrenba** » Wed Oct 14, 2020 8:08 pm

Traditionally I've always done a mason mitre with router and jig. However this week I used this method and it's worked well.

https://www.youtube.com/watch?v=Q46oq6WV2kI

Bob225 · Post by **Bob225** » Thu Oct 15, 2020 12:17 pm

That poor, poor 2" Marple chisel

darrenba · Post by **darrenba** » Fri Oct 16, 2020 8:35 pm

Here's the result

fin · Post by **fin** » Sat Oct 17, 2020 10:20 pm

ive always used the router and jig method. seen it butt joined also... never actually done a one though