Page 1 of 1
Tiling down to shower tray...
Posted: Fri Jan 28, 2011 5:23 pm
by blakes
Going from an earlier post which made me aware of tile 'movement' am I right in assuming that when tiling down to the shower tray, the tiles don't want to be in contact with the tray i.e sit them on a 3mm spacer and then when I've finished, use silicone to seal?
Thanks in advance.
Re: Tiling down to shower tray...
Posted: Fri Jan 28, 2011 5:32 pm
by big-all
mark the wall 1 tile +4mm above the tray[more iff not self spacing] secure a batton on the line
remember to silicon the tray to the wall before tiling down an siliconing again
Re: Tiling down to shower tray...
Posted: Sat Jan 29, 2011 1:49 am
by tictic
big-all wrote:mark the wall 1 tile +4mm above the tray[more iff not self spacing] secure a batton on the line
remember to silicon the tray to the wall before tiling down an siliconing again
if using battons in a wet area...be carefull you dont peirce the tanking(IF USING THESE).. when your using batton etc...or all bets are OFF...(mfr instructions)...