www.ultimatehandyman.co.uk

Im in negotiatiation with my boss as to why he needs to buy me a right angle drill,my job is fitting Beer lines behind the bar and i have to drill combinations of 1" 2" 3" holes using hole cutters,as some of you may appreciate getting access to the back of the bar is a right pain in the butt hence the need for a angle drill.
So if i was to drill half a dozen 3" holes what angle drill would be the best buy looking for something that wouldnt burn out after a few uses as this will be a one off purchace the boss is a tight arse

Oh and it needs to be 110 volt

have you thought about a naked one to go with your battery kit
i got a 18v dewalt for £60

I have the 18 volt dewalt one as well and it is very handy

Hes not likely to buy a top notch one is he....?

http://www.lawson-his.co.uk/scripts/pro ... TADA4000LR
The middle one.


I will reccomend that bad boy.
Plenty of power for the big holesaws, and the end will rotate

big-all wrote:have you thought about a naked one to go with your battery kit
i got a 18v dewalt for £60

My Dewalt battery drill is 14.4 however i do have a Ryobi 18volt battery drill is there a angle drill made by Ryobi,i have looked on the Ryobi web site and nothings listed

http://www.ryobi-direct.com/acatalog/index.html

yes they do make one , looked on google and came up with this one, there was quite a few listed but heres the one i found.

http://www.newpowertool.co.uk/ryobi-18v ... 2113-p.asp


Nick

Excellent Sparkdude i know im harping on now but would a battery drill take the load of several 2/3" holes through hardwood carcases

depends how many batteries you have to do the job. Honestly if i was doing it as a job a mians one would have to be a must .
especially if the boss is buying it go for a decent one, he wont have to pay the vat anyways .

Nick

I agree with Nick, use a mains drill.

3" holesaws will kill batteries pretty sharpish.

A nice 110 one

Cannyfixit wrote:Excellent Sparkdude i know im harping on now but would a battery drill take the load of several 2/3" holes through hardwood carcases

ok 3" holes in hardwood may be pushing it a bit i will try my dewalt with a 3" in 20mm pine later as i dont have a bit of 3" hardwood handy

tried the dewalt worked fine on a 20mmx76mm hole in close grain quite hard redwood
drilled 3 holes on a battery thats been lying around uncharged for several weeks did warm up a bit but not to bad
wouldnt fancy 6 holes in harder wood without a breather after the third to cool down though

Much appreciated guys,looks like 110 volt is the way to go,now i can go back to my boss and he will think i'm dead clever l

Try and get that Makita out of him