Page 1 of 1

Tilling my bathroom floor

Posted: Thu May 16, 2013 3:33 pm
by andy216
Afternoon all,

Just got a question, I have just bought a house with carpet in all bathrooms. I want tile all the floors I know I have to ply board the upstairs floors. My question is should I tile around the sink pedestal & toilet or remove them?

Cheers in advance.

Andy

Re: Tilling my bathroom floor

Posted: Thu May 16, 2013 3:36 pm
by DTWCeramics
Personally I would tile the floor, and place sanitaryware on top of this.

Cheers to you too!

Matt :thumbleft:

Re: Tilling my bathroom floor

Posted: Thu May 16, 2013 3:58 pm
by andy216
Thanks for your fast response, if I tile the floors and place the sanitary ware back on top surely I will have to adjust the basin height on the wall and toilet waste pipe??

Re: Tilling my bathroom floor

Posted: Thu May 16, 2013 10:22 pm
by royaloakcarpentry
Why are they carpeted................might be that there is too much flex in the floor for tiling.

make sure any flex issues are dealt with otherwise you will have a failure of grout/adhesive bond or cracked tiles.

Re: Tilling my bathroom floor

Posted: Fri May 17, 2013 7:01 pm
by andy216
I think it's been carpeted as a cost saver, all the other houses in my road are the same. I will do a flex test prior to plying the floor and after I have pled the floor. see if any movement.

Re: Tilling my bathroom floor

Posted: Fri May 17, 2013 8:35 pm
by royaloakcarpentry
15mm ply is what you need.

Re: Tilling my bathroom floor

Posted: Fri May 17, 2013 8:49 pm
by andy216
Great, thanks for the advise I will check over the weekend and make a start.