Toilet under tiles

hooly · Post by **hooly** » Thu May 07, 2009 3:43 pm

I want to take the toilet up, and tile under, Plumbing know how = zero

hooly · Post by **hooly** » Thu May 07, 2009 3:44 pm

Can i get a flexible bit, as the toilet will lift quite a bit higher?

thescruff · Post by **thescruff** » Thu May 07, 2009 5:44 pm

You should be able to use what you already.

Note the extension piece isn't fully inserted, it looks as though its pulled out.

m3 fitter · Post by **m3 fitter** » Fri May 08, 2009 4:38 am

if not use a jollyflex pan connector from the original svp and then connect your existing 90 to the end, to be safe, available from most diy stores and here:
http://www.toolstation.com/shop/Plumbin ... 887/p65378

hooly · Post by **hooly** » Fri May 08, 2009 4:37 pm

thescruff wrote:You should be able to use what you already.

Note the extension piece isn't fully inserted, it looks as though its pulled out.

Just checked, its in tight, wont go no more, at the limit

cheers both

thescruff · Post by **thescruff** » Fri May 08, 2009 5:18 pm

There's nearly three fins sticking out which shouldn't be, try twisting and pushing at the same time.

How much are you looking to raise the pan.

If you go for the jollyflex pan connector ( I would use whats there) get the bent type so you only need one fitting.

hooly · Post by **hooly** » Fri May 08, 2009 6:56 pm

12 mill ply, 8 mill tile, and the say 5 mill of adhesive..approx

will try when i go back upstairs

thescruff · Post by **thescruff** » Fri May 08, 2009 7:15 pm

Are you keeping the existing suite, the outlet height varies quite a bit.

Looking at the pic, so it's not clear, but I would go for a plastic socket on the existing pipe with a short length of pipe and a 112% bend into a bent pan connector, that would give you around 25-30mm

hooly · Post by **hooly** » Wed May 13, 2009 4:16 pm

I think the right side pipe is too far in the middle bit, hense that not fitting right, cheers

I have a idea what i now need when its raised